Epson AcuLaser C8500 Service Manual page 426

EPSON AcuLaser C8500
FIP-1.45 Error in standard RAM FIP-1.45 Error in standard RAM FIP-1.45 Error in standard RAM FIP-1.45 Error in standard RAM
Step
*Initial setting
• Remove all of the option units related to electricity and modules.
1
Bring everything back to a normal status.
• Check if all connectors are properly connected to the CONTROLLER PWB.
*SD-RAM check
• Remove all SD-RAMs from the RAM slots in order of 0, 1, and 2, and then re-insert them in
the RAM slots.
• Make sure to insert each SD-RAM one by one (S0, S1, and S2) so that the SD-RAM error can
be identified.
• Every time you insert a SD-RAM, make sure to follow the procedures below and repeat it for
each one.
Turn the power off.
2
Add the SD-RAM.
Turn the power on.
• Insert the SD-RAM in the socket until it locks securely.
NOTE: Since the SD-RAM has the right direction to insert, make sure to insert it in
the correct direction.
• Made sure the Slot0 is set in the standard SD-RAM(32MB).
Troubleshooting
Check
Level 1 FIP (Fault Isolation Procedure)
Treatment
Yes
Replace and remount
Go to step 2.
the concerned part(s).
Replace and remount
Problem solved.
the concerned part(s).
Revision C
No
5-74