Front Paper Guide Removal - Epson Stylus PHOTO 950 Service Manual

EPSON Stylus PHOTO 950

4.2.8 Front Paper Guide Removal

1. Remove the Carriage Unit. (Refer to Section 4.2.6.)
2. Disengage the hooks at both ends of the front paper guide.
Figure 4-50. Hook Disengaging
3. Push the front paper guide upward from blow, and then turn it to the front to
disengage the three hooks and remove the front paper guide.
Front Paper Guide
Figure 4-51. Front Paper Guide Removal
DISASSEMBLY AND ASSEMBLY
Hooks
Hooks
Be careful not to break the hooks of the front paper guide that
C A U T I O N
are shown in Figure 4-50 and Figure 4-51.
The previous procedure describes the method of removing the
Front Paper Guide. If the procedure is not carefully followed,
the power coating on the surface of the PF Roller may come off,
and this could have an adverse effect on the paper feed pitch to
an extent that could be noticeable to the user. Accordingly, when
removing the Front Paper Guide, take particular care not to
touch the surface of the PF Roller. Furthermore, this should also
be observed when installing the PF Roller. Specifically, contact
with the surface of the PF Roller can be avoided by rotating it to
the front while removing it.
Disassembly
Revision A
117