QUANTA QuantaGrid S31A-1U User Manual page 90

BMC
Table 11: DNS Server Settings Page (Continued)
I
TEM
R BMC
EGISTER
TSIG Authentica-
tion
Current TSIG Pri-
TSIG
vate File
C
ONFIGURATIO
N
New TSIG Private
File
Domain Settings
D N
OMAIN AME
C
ONFIGURATIO
N
Domain Name
DNS Server
Settings
IP Priority
D N
OMAIN AME
S C -
ERVER ON
FIGURATION
DNS Server1,
DNS Server2, and
DNS Server3
S
AVE
R
ESET
Procedure:
To enable/disable Register BMC.
To enable/disable TSIG authentication while registering in DNS via
Direct Dynamic DNS.
The information of Current TSIG private file along with its up¬loaded
date/time will be displayed (read only).
Browse and navigate to the TSIG private file.
Note:
TSIG file should be of private type.
It lists the option for domain interface as Manual, v4 or v6 for multiLAN
channels.
Note:
If you choose DHCP, then select v4 or v6 for DHCP servers.
It displays the domain name of the device. If the Domain setting is cho-
sen as Manual, then specify the domain name of the device. If you chose
Automatic, the Domain Name cannot be configured as it will be done
automatically. The field will be disabled.
It lists the option for DNS settings for the device, Manual and available
LAN interfaces. If you choose Manual setting, you have to configure the
DNS Server IP addresses. If you have chosen DHCP, then you have to
select the interface from which the IP address is to be received.
If IP Priority is IPv4, it will have 2 IPv4 DNS servers and 1 IPv6 DNS server.
If IP Priority is IPv6, it will have 2 IPv6 DNS servers and 1 IPv4 DNS server.
Note:
It is not applicable for Manual configuration.
Specify the DNS (Domain Name System) server address to be config-
ured for the BMC.

IPv4 Address made of 4 numbers separated by dots as in
"xxx.xxx.xxx.xxx".
 Each number ranges from 0 to 255.
 First number must not be 0.
DNS Server Address will support the following:
 IPv4 Address format.
 IPv6 Address format.
Note:
 If IP Priority is IPv4 then DNS Server1, DNS Server2 will be IPv4
and DNS Server3 will be IPv6.
 If IP Priority is IPv6 then DNS Server1, DNS Server2 will be IPv6
and DNS Server3 will be IPv4.
 If no IP, DNS Server field will be empty.
To save the entered changes.
To reset the entered changes.
C
ONFIGURATION
D
ESCRIPTION
G
ROUP
3-32