Preserve Configuration - QUANTA QuantaGrid S31A-1U User Manual

BMC

Preserve Configuration

This page allows the user to configure the preserve configuration items, which will be
used by the Restore factory defaults to preserve the existing configuration without over-
writing with default configuration.
Item Verification Procedure
1. SDR
Step 1: add OEM record (Please refer to IPMI 2.0 Spec. page 468/644)
Command: ipmitool raw 0x0a 0x24 0x0 0x0 0x51 0xc0 4 0x57 0x01 0x0 0xf5
Response: 55 00 „» 55 is the last record ID
Step 2: get OEM record, to use the last record ID to check if added successfully
(Please refer to IPMI 2.0 Spec. page 466/644)
Command: ipmitool raw 0x0a 0x23 0x0 0x0 0x55 0x0 0x0 0xff
Response: ff ff 55 00 51 c0 04 57 01 0 f5 „» ff ff means record ID 55 is the last record ID
Step 3: go to Web-UI to check "SDR" to be preserved
Step 4: upgrade firmware
Step 5: after Step 4, go to Step 2 and check if the OEM record is still preserved
(if preserved then PASS, else FAIL)
2. SEL
Step 1: Please use IPMI command to add an event. Ex: ipmitool event 1
Step 2: go to Event Log to check if the event added
Step 3: go to Web-UI to check "SEL" to be preserved
Figure 3-52. Preserve Configuration Page
M G
AINTENANCE ROUP
3-86