QUANTA QuantaGrid S31A-1U User Manual page 87

BMC
Note:
 Default Time out value: 120 seconds.

Range from 15 to 300 allowed.
6. Configure IP addresses in Domain Controller Server Address1, Domain Control-
ler Server Address2 & Domain Controller Server Address3.
Note:
IP address of Active Directory server: At least one Domain Controller Server Address must be
configured.
 IP Address made of 4 numbers separated by dots as in "xxx.xxx.xxx.xxx".
 Each number ranges from 0 to 255.
 First number must not be 0.
Domain Controller Server Addresses will support IPv4 Address format and IPv6 Address for-
mat.
7. Click Save to save the settings and return to Active Directory Settings Page.
8. Click Cancel to cancel the entry and return to Active Directory Settings Page.
To add a new Role Group
1. Select a blank row and click Add Role Group in the Active Directory Settings Page
to open the Add Role Group Page as shown in the screenshot below.
2. Enter the name that identifies the role group in the Active Directory from the Role
Group Name field.
Note:
 Role Group Name is a string of 255 alpha-numeric characters.
 Special symbols hyphen and underscore are allowed.
3. Enter the domain where the role group is located in the Role Group Domain field.
Note:
 Domain Name is a string of 255 alpha-numeric characters.
 Special symbols hyphen, underscore and dot are allowed.
4. Enter the level of privilege to assign this role group in the Role Group Privilege
field.
Figure 3-18. Add Role Group Page
C G
ONFIGURATION ROUP
3-29