QUANTA QuantaGrid S31A-1U User Manual page 102

BMC
Select any one of the Power action either Power down, Power reset or Power cycle

from the drop down list
Choose any one of the configured alert policy number from the drop down list.

Note:
Alert Policy has to be configured - under Configuration -> PEF -> Alert Policy.
5. In the Generator ID configuration section,
Check Generator ID Data option to fill the Generator ID with raw data.

Generator ID 1 field is used to give raw generator ID1 data value.

Generator ID 2 field is used to give raw generator ID2 data value.

Note:
In RAW data field, specify hexadecimal value prefix with '0x' .
In the Event Generator section, choose the event generator as Slave Address - if

event was generated from IPMB. Otherwise as System Software ID - if event was
generated from sys-tem software.
In the Slave Address/Software ID field, specify corresponding I2C Slave Address

or System Software ID.
Choose the particular Channel Number that event message was received over.

Or choose '0' if the event message was received via the system interface, primary
IPMB, or internally generated by the BMC.
Choose the corresponding IPMB Device LUN if event generated by IPMB.

6. In the Sensor configuration section,
Select the sensor type of sensor that will trigger the event filter action.

In the sensor name field, choose the particular sensor from the sensor list.

Choose event option to be either All Events or Sensor Specific Events.

7. In the Event Data configuration section,
Event Trigger field is used to give Event/Reading type value.

Note:
Value ranges from 1 to 255.
Event Data 1 AND Mask field is used to indicate wildcarded or compared bits.

Note:
Value ranges from 0 to 255.
Event Data 1 Compare 1 & Event Data 1 Compare 2 field is used to indicate

whether each bit position's comparison is an exact comparison or not.
C G
ONFIGURATION ROUP
3-44