Configuring The Sip Signaling Protocol; Figure 9-1: Signaling Protocol Tab Screen; Table 9-1: Signaling Protocol Tab Parameters Description - AudioCodes MP-20 Series User Manual

9.1

Configuring the SIP Signaling Protocol

The procedure below describes how to configure the SIP parameters.

To configure SIP parameters:
1. From the menu bar, click the Voice Over IP menu; the following screen appears:
2. Configure the parameters, as required. For a description of the parameters displayed
on this screen, see
3. Click OK to save your settings.

Table 9-1: Signaling Protocol Tab Parameters Description

Parameter
Signaling Protocol Group
Signaling Protocol
protocol
SIP Transport Protocol
transport_protocol
Local SIP Port
port
Local SIP TLS Port
tls_port
User's Manual

Figure 9-1: Signaling Protocol Tab Screen

Table 9-1.
(Read-only field.) Displays the signaling protocol running on
the device.
Note: Currently, only SIP is supported.
Defines the SIP transport type - UDP (default), TCP, or TLS.
Note: This parameter appears only in 'Advanced' mode.
Defines the UDP / TCP port on which the SIP stack listens.
The default port is 5060.
Note: This parameter appears only in 'Advanced' mode.
Defines the TLS port on which the SIP stack listens. The
default port is 5060.
Note: This parameter appears only if you select 'TLS' as the
SIP transport protocol.
74
MP-20x Multimedia Home Gateway
Description
Document #: LTRT-50614