Figure 4-12. Using The Cable Looms - Nortel Passport 5430 Installing And Operating Instructions

Installing and Operating the Passport 5430 Multiservice Access Switch
Cable loom
Figure 4-12. Using the Cable Looms
To use the cable looms:
Make sure that the cable looms are installed as described in "Installing
1.
the Passport 5430" on page 1-5.
Using the guidelines above, determine which card to cable first.
2.
If you are cabling a port on a PCI card, begin with the Module 1 port.
Insert the cable into the cable loom slot corresponding to the card
3.
containing the module you are cabling.
Allowing some slack in the cable between the cable loom and the module
4.
connector, insert the cable into the module connector.
For cabling instructions, see
page
Remove excess cable slack by slowly pulling the cable through the cable
5.
loom away from the connector.
To ease card removal, the cable should curve naturally and not drape over
other cards and modules. Make sure that cables can be quickly reconnected to
the appropriate connector.
4-18
2
3
4-1, and "Connecting a Management
"Connecting Communications
Console" on
FBR0110A
Cables" on
page 4-7.
306308-A Rev 00