Table of Contents
Advertisement
Installing and Operating the Passport 5430 Multiservice Access Switch
To change flash memory card protection:
Remove the memory card as described on
1.
Adjust the read-write protect switch, which is located on the edge
2.
opposite the INSERT arrow of the memory card
Figure 6-7.
Reinsert the memory card into the card receptacle (see Figure 5-2 on
3.
page 5-7).
Removing a Flash Memory Card
To remove a flash memory card from the Passport 5430:
Press the eject button next to the card receptacle on the front panel (see
1.
Figure 6-8 on
The card pops out slightly.
Pull the memory card out of the card receptacle.
2.
Caution: Do not remove the flash memory card while the switch is operating
unless you verify that other users are not writing to the flash card.
6-12
Insert
Memory Card Read/Write Protect Switch
page
6-13).
page
6-12.
(Figure
6-7).
Unprotected
Protected
VLK0002A
306308-A Rev 00
Advertisement
Table of Contents
