Table of Contents
Advertisement
Installing and Operating the Passport 5430 Multiservice Access Switch
Installing a PMC Module on the Expansion Card
To install a PMC module on the expansion card for the first time:
Put on an antistatic wrist strap.
1.
Caution: Electrostatic discharge can damage hardware. You must wear the
antistatic wrist strap on your arm whenever you handle printed circuit boards.
For instructions, see "Attaching the Antistatic Wrist Strap" on page 3-2.
Place the expansion card on a flat surface.
2.
If you are installing 2 PMC modules, push the PMC module filler panel
3.
out from behind the card bezel (see
Make sure that you are installing the appropriate PMC module on the
4.
expansion card.
For instructions, see
Hold the PMC module with the connectors facing down.
5.
2-12
Figure 2-8
Table 2-1
on
page
2-3.
on
page
2-10).
306308-A Rev 00
Advertisement
Table of Contents
