Chapter 8: Install The Ip Deskphone - Avaya 1230 Administration

Chapter 8: Install the IP Deskphone

Complete instructions to install the Avaya 1200 Series IP Deskphone, including detailed figures and
applicable warnings, are given in the Avaya IP Deskphones User Guides.
The steps for installing the Avaya 1200 Series IP Deskphone are summarized in the following
procedure.
Installing the IP Deskphone
1. Remove the stand cover. Pull upward on the center catch and remove the stand cover. The
cable routing tracks are now accessible.
2. Connect the AC power adapter (optional). Connect the adapter to the AC adapter jack in the
bottom of the IP Deskphone. Form a small bend in the cable, and then thread the adapter
cord through the channels in the stand.
3. Install the handset. Connect the end of the handset cable with the short straight section into
the handset. Connect the end of the handset cable with the long straight section to the back
of the IP Deskphone, using the RJ-9 handset jack. Form a small bend in the cable, and then
thread the handset cord through the channels in the stand so that it exits behind the handset
on the right side, in the handset cord exit in the stand base.
4. Install the headset (optional). If installing a headset, plug the connector into the RJ-9 headset
jack on the back of the IP Deskphone, and thread the headset cord along with the handset
cord through the channels in the stand, so that the headset cord exits the channel.
5. Install the Ethernet cable. Connect one end of the supplied Ethernet cable to the back of the
IP Deskphone using the RJ-45 connector and thread the network cable through the channel.
6. Install the Ethernet cable connecting the PC to the IP Deskphone (optional). If connecting
PC Ethernet through the IP Deskphone, connect one end of the PC Ethernet cable to the
IP Deskphone using the RJ-45 connector and thread it through the channel. Connect the
other end to the LAN connector on the back of the PC.
7. Install additional cables. Connect the Ethernet cable to the LAN Ethernet connection. If using
an AC power adapter, plug the adapter into an AC outlet.
8. Wall-mount the IP Deskphone (optional). The IP Deskphone can be mounted either by:
(method A) using the mounting holes on the bottom of the IP Deskphone stand, or (method
B) using a traditional-style wall-mount box with RJ-45 connector and 15-cm (6-inch) RJ-45
cord (not provided).
9. Replace the stand cover. Ensure that all cables are neatly routed and press the stand cover
into place until a click is heard.
10. Put the IP Deskphone in the wall-mount position (optional). If the IP Deskphone is to be
mounted on the wall, put it in the wall-mount position by holding the tilt lever and pressing
the IP Deskphone towards the base until the IP Deskphone is parallel with the base.
March 2015 SIP Software for Avaya 1200 Series IP Deskphones-Administration
Comments? infodev@avaya.com
115