System > Ipv6 Settings > Ipv6 Default Gateway Settings; System > Ipv6 Settings > Ipv6 Neighbor Settings - D-Link DSG-1100-10/ME Manual

D-Link DGS-1100-10/ME User Manual
Figure 4.18 – System > IPv6 Settings > IPv6 System Settings
IPv6 System Settings:
Interface Name: Displays the IPv6 interface name.
IPv6 State: Select to either enable or disable IPv6.
DHCPv6 Client: Select to either enable or disable the switch as an IPv6 client.
IPv6 Network Address: Specifies the IPv6 Network Address.
NS Retransmit Time Settings:
NS Retransmit Time (1-3600): Enter the Neighbor Solicitation's retransmit timer in seconds. The field range
is 1-3600, and default is 1 second.
Automatic Link Local State Settings:
Automatic Link Local Address: Select either Enabled or Disabled.
Click Apply for the settings to take effect.
System > IPv6 Settings > IPv6 Default Gateway Settings
From this page you can configure the IPv6 gateway settings.
Figure 4.19 – System > IPv6 Settings > IPv6 Route Settings
IP Interface: Specify the IP interface which to be created.
Default Gateway: The corresponding IPv6 address for the next hop Gateway address in IPv6 format.
Metric: Represents the metric value of the IP interface entered into the table. This field may read a number
between 1 and 65535.
Click Create to accept the changes made or and click the Delete button to remove the entry.
System > IPv6 Settings > IPv6 Neighbor Settings
You can configure the Switch's IPv6 neighbor settings. The Switch's current IPv6 neighbor settings will be
displayed in the table at the bottom of this window.
Figure 4.20 – System > IPv6 Settings > IPv6 Neighbor Settings
Interface Name: Enter the interface name of the IPv6 neighbor.
Neighbor IPv6 Address: Enter the neighbor IPv6 address.
2 2 3 3