Invacare HomeFillII AW Service Manual page 48

SECTION 8—BASE REPLACEMENT
23. Remove the six mounting screws that secure the pump/motor assembly to the base
(FIGURE 8.5).
TOP VIEW WITH CONTROL PANEL ASSEMBLY REMOVED
Base
Mounting
Screws
24. Cut the tie wrap that secures the capacitor in place and remove capacitor
(FIGURE 8.6).
NOTE: Located underneath the capacitor is a tie wrap mount.
25. Remove the mounting screw that secures the tie wrap mount (not shown) to the base.
26. Remove the tie wrap mount (not shown).
27. Remove the two mounting screws that secure the transformer to the base
(FIGURE 8.6).
28. Remove the transformer from the base (FIGURE 8.6).
29. Remove the two mounting screws that secure the power inlet to the base
(FIGURE 8.6).
30. Remove the power inlet from the base (FIGURE 8.6).
®
HomeFill II AW Compressor
Mounting Screws
FIGURE 8.5 Base Replacement
48
Motor/Pump Assembly
Mounting
Screws
Part No 1154316