Show Pppoe Throttles - Cisco ASR 9000 Series Command Reference Manual

PPPoE Commands

show pppoe throttles

To show the throttle information for the PPPoE sessions, use the show pppoe throttles command in the EXEC
mode mode.
show pppoe throttles [active] [access-interface type interface-path-id | bba-group bba-group-name | location
node]
Syntax Description
active
access-interface
type
interface-path-id
bba-group
bba_group_name
location
node
Command Default
None
Command Modes
EXEC mode
Command History
Release
Release 4.2.0
Release 4.3.1
Shows only those throttles that are currently blocking packets.
Shows PPPoE status for all sessions on a single access interface.
Interface type. For more information, use the question mark (?) online help
function.
Physical interface or virtual interface.
Note
For more information about the syntax for the router, use the question mark
(?) online help function.
Shows throttles for all interfaces with a given bba-group.
Specifies the bba-group name.
Shows PPPoE status for all sessions at a location.
Specifies the fully qualified location specification.
Modification
This command was introduced.
The command output was extended for the throttle for circuit-id,
remote-id, inner-vlan, outer-vlan, vlan and circuit-id-and-remote-id.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
Use the show interfaces command to see a list of all interfaces
currently configured on the router.
show pppoe throttles
5.2.x
475