Cisco ASR 9000 Series Command Reference Manual page 475

PPPoE Commands
Command Modes
PPPoE BBA-Group configuration
Command History
Release
Release 4.2.0
Release 4.3.1
Usage Guidelines
If both mac access-interface throttle and mac-iwf access-interface throttle are configured, only IWF throttle
is used for IWF sessions, so that different throttling can be applied to IWF and non-IWF sessions.
Task ID
Task ID
ppp
Examples This example shows how to configure a throttle for pppoe sessions for each circuit-id in a PPPoE BBA-Group:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# pppoe bba-group bba1
RP/0/RSP0/CPU0:router(config-bbagroup)# sessions circuit-id throttle 1000 50 25
This example shows how to configure a throttle for IWF session requests for each peer mac-address under
individual access-interface in a PPPoE BBA-Group:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# pppoe bba-group bba1
RP/0/RSP0/CPU0:router(config-bbagroup)# sessions mac-iwf access-interface throttle 5000 100
50
Related Commands
Command
pppoe sessions limit, on page 457
show pppoe throttles, on page 475
Modification
This command was introduced.
The pppoe sessions throttle support was extended for circuit-id, remote-id,
inner-vlan, outer-vlan, vlan and circuit-id-and-remote-id
Support for the variables, request-count, request-period and blocking-period
was added.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
Operation
read, write
Description
Configures a limit for PPPoE sessions for a PPPoE BBA-Group
in BNG.
Shows the throttle information for the PPPoE sessions.
pppoe sessions throttle
5.2.x
461