Cisco ASR 9000 Series Command Reference Manual page 332

show ipv6 interface (BNG)
Command Modes
EXEC mode
Command History
Release
Release 3.7.2
Release 4.3.0
Release 5.1.2
Usage Guidelines
The show ipv6 interface command provides output similar to the show ipv4 interface command, except that
it is IPv6-specific.
Use the link-local or global keywords along with the brief keyword to view the link local or global IPv6
addresses.
Task ID
Task ID
ipv6
Examples
This is the sample output of the show ipv6 interface command:
RP/0/RSP0/CPU0:router# show ipv6 interface
GigabitEthernet0/2/0/0 is Up, line protocol is Up, Vrfid is default (0x60000000)
IPv6 is enabled, link-local address is fe80::212:daff:fe62:c150
Global unicast address(es):
Joined group address(es): ff02::1:ff00:1 ff02::1:ff62:c150 ff02::2
MTU is 1514 (1500 is available to IPv6)
ICMP redirects are disabled
ICMP unreachables are enabled
ND DAD is enabled, number of DAD attempts 1
ND reachable time is 0 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND router advertisements are sent every 200 seconds
ND router advertisements live for 1800 seconds
Hosts use stateless autoconfig for addresses.
Outgoing access list is not set
Inbound
This table describes the significant fields shown in the display.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
318
202::1, subnet is 202::/64
ff02::1
access list is not set
Modification
This command was introduced.
This command was supported for
BNG.
The link-local and global
keywords were added to the
command.
Operations
read
IPv4 and IPv6 Commands