L2Tp Reassembly - Cisco ASR 9000 Series Command Reference Manual

l2tp reassembly

l2tp reassembly
To configure the L2TP reassembly feature on L2TP Access Concentrator (LAC), use the l2tp reassembly
command in VPDN configuration mode. To disable this feature, use the no form of this command.
l2tp reassembly
no l2tp reassembly
Syntax Description
This command has no keywords or arguments.
Command Default
None
Command Modes
VPDN configuration
Command History
Release
Release 4.3.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the vpdn command inGlobal Configuration mode to enter the VPDN configuration mode.
When the L2TP reassembly is enabled, the line card supports 2000 concurrent flows in a steady state condition
and the traffic rate supported for each line card is 10,000 packets per second (pps), which is 10,000 packet
fragments IN per second and 5000 reassembled packets OUT per second.
Task ID
Task ID
tunnel
Examples This example shows how to enable the L2TP reassembly feature on LAC:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# vpdn
RP/0/RSP0/CPU0:router(config-vpdn)# l2tp reassembly
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
414
Modification
This command was introduced.
Operation
read, write
PPPoE LAC-Specific Commands