Ipv6 Nd Suppress-Ra (Bng) - Cisco ASR 9000 Series Command Reference Manual

Neighbor Discovery Commands

ipv6 nd suppress-ra (BNG)

To suppress IPv6 router advertisement transmissions on a LAN interface, use the ipv6 nd suppress-ra
command in an appropriate configuration mode. To reenable the sending of IPv6 router advertisement
transmissions on a LAN interface, use the no form of this command.
ipv6 nd suppress-ra
no ipv6 nd suppress-ra
Syntax Description
This command has no keywords or arguments.
Command Default
IPv6 router advertisements are automatically sent on other types of interlaces if IPv6 unicast routing is enabled
on the interfaces. IPv6 router advertisements are not sent on other types of interfaces.
Command Modes
Interface configuration (not applicable for BNG)
Dynamic template configuration (for BNG)
Command History
Release
Release 3.7.2
Release 4.3.0
Usage Guidelines
Use the no ipv6 nd suppress-ra command to enable the sending of IPv6 router advertisement transmissions
on non-LAN interface types (for example, serial or tunnel interfaces).
For BNG, ensure you run this command in the dynamic template configuration mode. To enter the dynamic
template configuration mode, run dynamic-template command in the Global Configuration mode.
Task ID
Task ID
ipv6
network
config-services
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
Modification
This command was introduced.
This command was supported in the dynamic template configuration
mode for BNG.
Operations
read, write
read, write
read, write
ipv6 nd suppress-ra (BNG)
5.2.x
375