Set The Scanning Of The Originals; Automatically Scanning Both Sides Of An Original (2-Sided Original) - Sharp MX-2630N User Manual

FACSIMILE►BASIC TRANSMISSION METHODS

SET THE SCANNING OF THE ORIGINALS

AUTOMATICALLY SCANNING BOTH SIDES OF AN
ORIGINAL (2-Sided Original)
The automatic document feeder will automatically scan both sides of the document.
• 2-sided scanning is not possible when direct transmission or speaker transmission is performed.
• On the MX-2630N/MX-3050N/MX-3060N/MX-3550N/MX-3560N/MX-4050N/MX-4060N/MX-5050N/MX-6050N, duplex
scanning is not possible when originals of mixed width are scanned.
• You cannot use 2-sided scanning when the original size is set to Long Size.
2-sided scanning automatically turns off after transmission has ended.
1
Book
A
C
In normal mode, tap the [2-Sided Booklet] key or [2-Sided Tablet] key.
2
Original
Auto
Long Size
CA
Preview
To cancel 2-sided scanning:
Tap the [1-Sided] key.
In normal mode, tap the [2-Sided Booklet] key or the [2-Sided Tablet] key that has been forcibly displayed and cancel the
display.
Send
2-Sided Original
Tablet
J
A B
E F
L
K L
Image
Orientation
Duplex Setup
1-Sided Book Tablet
Start
Two pages are sent as a single page (N-Up)
Tap the [Original] key, and tap the
[Book] key or [Tablet] key.
See the figure on the left to check the binding edge of the
original and select the key to be tapped.
Tap the [Image Orientation] key with
the same orientation as the placed
original.
If this setting is not correct, a suitable image may not be
transmitted.
After the settings are completed, tap
4-45
.