Scanning A Large Number Of Originals (When An Rspf Is Installed) - Sharp MX-M260 Operation Manual

SCANNING A LARGE NUMBER OF ORIGINALS (when
an RSPF is installed)
If you have a large number of originals, the originals can be scanned in batches using the RSPF.
1
Make sure the machine is in scanner
mode and then load the document in
the RSPF. (p.72)
2
Touch the [ORIGINAL] key.
300dpi
RESOLUTION
TIFF-G4
FILE FORMAT
AUTO A4
ORIGINAL
3
Touch the [JOB BUILD] key.
RIGINAL SIZE
OK
MANUAL
2-SIDED JOB
TABLET BUILD
ROTATE THE IMAGE 90 DEGREES
If the correct original size does not appear in
Note
the screen of step 2, touch the [MANUAL] key
and specify the correct original size (p.78).
4
Touch the [OK] key.
NAL SIZE
OK
MANUAL
2-SIDED JOB
TABLET BUILD
ROTATE THE IMAGE 90 DEGREES
• Job build mode turns off after transmission is finished. Job build mode can also be cancelled by pressing the
Note
[CLEAR ALL] key ( ).
• When performing Scan to E-mail, see the notes on page 74.
If you wish to rotate the
original 90° when creating
an image file, touch the
[ROTATE THE IMAGE 90
DEGREES] checkbox (a
checkmark should appear
in the box).
You will return to the
initial screen.
NETWORK SCANNER FUNCTION
5
Perform steps 4 through 9 of "BASIC
TRANSMISSION METHOD". (p.72 to 73)
6
Press the [START] key (
7
When all of the originals in the RSPF
have been scanned, load the next
batch and press the [START] key (
Repeat this sequence until all pages have been
scanned.
If no action is taken for one minute, scanning
Note
automatically ends and transmission begins.
8
When all originals have been
scanned, touch the [READ-END] key.
ESS [START].
EAD-END].
READ-END
).
Scanning of the originals
begins. A message
appears in the touch
panel.
).
"SENDING. PRESS [C]
TO CANCEL." appears in
the touch panel and
transmission begins.
When transmission is
finished, "SENDING
COMPLETED." appears
in the touch panel.
77
4