Parameter List - Siemens SINAMICS V90 Operating Instructions Manual

Parameters

10.2 Parameter list

Parameter groups
The SINAMICS V90 parameters are divided into the following groups:
Parameter group
Basic parameters
Gain adjustment parameters
Speed control parameters
Torque control parameters
Position control parameters
I/O parameters
Status monitoring parameters
10.2 Parameter list
Editable parameters
The values of the parameters marked with an asterisk (*) may be changed after
commissioning. Make sure you back up the parameters first as required if you desire to
replace the motor. The default values of the parameters marked with two asterisks (**) are
motor dependent. They may have different default values when different motors are
connected.
Par. No. Name
p0748 CU invert digital outputs
Description: Inverts the signals at the digital outputs.
Bit 0 to bit 5: invert signal for DO 1 to DO 6.
•
– Bit = 0: not inverted
– Bit = 1: inverted
286
Available parameters
p290xx
p291xx
p10xx to p14xx, p21xx
p15xx to p16xx
p25xx to p26xx, p292xx
p293xx
All read-only parameters
Min Max
0 63
Parameter group display on
the BOP
Factory Unit Data
Setting type
0 - U32
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 09/2016, A5E36037884-002
Effective Can be
changed
IM T, U