Siemens SINAMICS V90 Operating Instructions Manual page 143

Display Example
Jog
Save
defu
dr--sd
sd--dr
Update
A OFF1
A OFF2
ABS
A.B.S.
r xxx
r -xxx
T x.x
xxxxxx
xxxxxx.
T -x.x
DCxxx.x
Exxxxx
run
Con
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 09/2016, A5E36037884-002
Description
Jog function
Save data in drive
Restore drive to default settings
Save data from drive to micro SD
card/SD card
Upload data from micro SD
card/SD card to drive
Update firmware
Adjust AI1 offset
Adjust AI2 offset
The zero position has not been set
The zero position has been set
Actual speed (positive direction)
Actual speed (negative direction)
Actual torque (positive direction)
Actual position (positive direction)
Actual position (negative direction)
Actual torque (negative direction)
Actual DC link voltage
Position following error
The motor is running
The communication between the
SINAMICS V-ASSISTANT and the
servo drive is established.
In this case, the BOP is protected
from any operations except clear-
ing alarms and acknowledging
faults.
Basic operator panel (BOP)
Remarks
Refer to "JOG (Page 151)".
Refer to "Saving parameters (RAM to ROM)
(Page 153)".
Refer to "Setting parameters to default
(Page 153)".
Refer to "Transferring data (drive to SD)
(Page 154)".
Refer to "Transferring data (SD to drive)
(Page 155)".
Refer to "Updating firmware (Page 156)".
Refer to "Adjusting AI offsets (Page 157)".
Refer to "Adjusting AI offsets (Page 157)".
Refer to "Adjusting an absolute encoder
(Page 158)".
Refer to "Adjusting an absolute encoder
(Page 158)".
Only the last six digits displays due to a lim-
ited display length.
Only the last six digits displays due to a lim-
ited display length.
6.1 BOP overview
143