Management Security Settings; Change Password - NETGEAR S3300 User Manual

Management Security Settings

From the Management Security menu, you can configure the login password, Remote
Authorization Dial-In User Service (RADIUS) settings, Terminal Access Controller Access
Control System (TACACS+) settings, and authentication lists.
The Management Security folder contains links described in the following sections.
•

Change Password

• RADIUS Configuration
• Configure TACACS+
• Authentication List Configuration
• Smart Control Center Utility
Change Password
Use this screen to change the login password.

To change the login password for the management interface:
1. Select Security > Management Security > User Configuration > Change Password.
2. Specify the current password in the Old Password field.
The entered password is displayed in asterisks (*). Passwords are 1–20 alphanumeric
characters in length and are case sensitive.
3. Enter the new password.
It does not display as it is typed, and only asterisks (*) will show on the screen.
Passwords are 1–20 alphanumeric characters in length and are case sensitive.
4. To confirm the password, enter it again to make sure you entered it correctly.
The password does not display, but will show asterisks (*)
5. Click the Apply button.

To reset the password to the default value:
1. Select the Reset Password check box.
2. Click the Apply button.
S3300 Smart Managed Pro Switch
on page 241
on page 243
on page 247
on page 249
on page 251
Managing Device Security
241