NETGEAR S3300 User Manual page 346

• Class Type. All
For more information about this step, see
2. Click the Class1 hyperlink to view the DiffServ Class Configuration screen for this class.
3. Configure the following settings for Class1:
• Protocol Type. UDP
• Source IP Address. 192.12.1.0
• Source Mask. 255.255.255.0
• Source L4 Port. Other, and enter 4567 as the source port value
• Destination IP Address. 192.12.2.0
• Destination Mask. 255.255.255.0
• Destination L4 Port. Other, and enter 4568 as the destination port value
For more information about this step, see
4. Click the Apply button.
5. From the Policy Configuration screen, create a new policy with the following settings:
• Policy Selector. Policy1
• Member Class. Class1
For more information about this step, see
6. Click the Add button to add the new policy.
7. Click the Policy1 hyperlink to view the Policy Class Configuration screen for this policy.
8. Configure the Policy attributes as follows:
• Assign Queue. 3
• Policy Attribute. Simple Policy
• Color Mode. Color Blind
• Committed Rate. 1000000 Kbps
• Committed Burst Size. 128 KB
• Confirm Action. Send
• Violate Action. Drop
For more information about this step, see
9. From the Service Configuration screen, select the check box next to interfaces g7 and g8 to
attach the policy to these interfaces,
For more information about this step, see
10. Click the Apply button.
All UDP packet flows destined to the 192.12.2.0 network with an IP source address from the
192.12.1.0 network that have a Layer 4 Source port of 4567 and Destination port of 4568
from this switch on ports 7 and 8 are assigned to hardware queue 3.
S3300 Smart Managed Pro Switch
Class Configuration
Class Configuration
Policy Configuration
Policy Configuration
Service Configuration
Configuration Examples
346
on page 231.
on page 231.
on page 235.
on page 235.
on page 238.