Configure Ip Settings; Ip Configuration - NETGEAR S3300 User Manual

Configure IP Settings

For information about how to configure and display IP routing data, see the following
sections:
•

IP Configuration

• VLAN Routing Wizard
• IP Statistics on page 211
IP Configuration
Use the IP Configuration screen to configure routing parameters for the switch.

To enable routing on the switch:
1. Select Routing > IP > IP Configuration.
2. Next to Routing Mode, select Enable.
You must enable routing for the switch before you can route through any of the interfaces.
Routing is also enabled or disabled per VLAN interface. The default value is Disable.
3. Click the Apply button.
The following table describes the IP configuration information displayed on the screen.
Table 78. Global IP Status Information
Field
Default Time to Live
Maximum Next Hops
S3300 Smart Managed Pro Switch
on page 210
on page 214
Description
The default value inserted into the Time-To-Live field of the IP header of
datagrams originated by the switch, if a TTL value is not supplied by the
transport layer protocol. The default value is 64.
The maximum number of hops supported by the switch. This is a compile-time
constant. The default value is 1.
Configuring Routing
210