NETGEAR S3300 User Manual page 138

elapses, or the utilization returns to a specified low threshold, the switch enables
the port to again transmit frames. The factory default is Disabled. When flow
control is disabled, the switch does not generate PAUSE frames. The switch also
does not throttle packet transmission on receiving PAUSE frames from a partner.
For LAG interfaces Flow Control Mode is displayed as blank because flow control
is not applicable.
- Symmetric — The port or device can send as well as honor the PAUSE frames.
The port or device generates PAUSE frames towards the peer in response to
congestion at ingress. The port or device is also capable of throttling the transmit
rate in response to the PAUSE frames received from the peer.
- Asymmetric — The port or device can honor the received PAUSE frames, but the
port or device cannot generate PAUSE frames towards peer in response to
congestion at ingress. The port or device is capable of throttling the transmit rate
in response to the pause frames received from peer.
4. Click the Apply button.
The following table shows the non-configurable information on the Port Configuration screen.
Table 47. Switching Ports Port Configuration
Field
Port Type
Physical Status
Link Status
MAC Address
PortList Bit Offset
ifindex
S3300 Smart Managed Pro Switch
Description
For most ports this field is blank. Otherwise, the possible values are:
• Trunk Member. The port is a member of a Link Aggregation trunk.
• Mirrored. The port is a mirrored port.
• Probe. The port is a monitoring port.
Indicates the physical port's speed and duplex mode
Indicates whether the link is up or down.
The physical address of the specified interface.
The bit offset value that corresponds to the port when the MIB object type
PortList is used to manage in SNMP.
The ifIndex of the interface table entry associated with this port. If the interface
field is set to All, this field is blank.
Configuring Switching
138