NETGEAR S3300 User Manual page 309

Figure 113. Traceroute IPv4
2. Use IP Address/Hostname to enter the IP address or Hostname of the station you want the
switch to discover a path. The default value is blank. The IP Address or Hostname you enter
is not retained across a power cycle.
3. Enter the number of Probes Per Hop, the number of times each hop should be probed. The
default value is 3. The range is 1 to 10. The Probes per Hop you enter is not retained across
a power cycle.
4. Enter the Maximum TTL, the maximum time-to-live for a packet in the number of hops for
the destination. The default value is 30. The range is 1 to 255. The MaxTTL you enter is not
retained across a power cycle.
5. Enter the Initial TTL the initial time-to-live for a packet in the number of hops. The default
value is 1. The range is 1 to 255.The InitTTL you enter is not retained across a power cycle.
6. Enter the Maximum Failures allowed in the session. The default value is 5. The range is 1
to 255. The MaxFail you enter is not retained across a power cycle.
7. Interval (secs) - Enter the number of seconds between probes. The default value is 3. The
range is 1 to 60. The Interval you enter is not retained across a power cycle.
8. Enter the UDP Destination Port in the probe packets. The default value is 33434. The range
is 1- 65535. The port you enter is not retained across a power cycle.
9. Enter the Size of the probe packets. The default value is 0. The range is 0 to 39936. The
Size you enter is not retained across a power cycle.
10. Enter the Source IP address or interface to use when sending the echo request packets. If
source is not required, select None as the source option. Possible values are:
• None — The source is the IP address of the default outgoing interface.
S3300 Smart Managed Pro Switch
Maintenance
309