NETGEAR S3300 User Manual page 204

In a similar manner, if EAV is enabled, then the stack port pages are disabled.
When stack ports are not configured (in other words, the 10G ports are configured as
Ethernet) and EAV is enabled globally:
1. Configure the Uplink ports in Ethernet mode and reload the switch, using the System >
Stacking > Advanced > Stack-port Configuration screen as shown in
Configure Uplink Ports in Ethernet
page 83
Figure 91. Configure Uplink Ports in Ethernet Mode
2. Next, enable 802.1AS using the Switching > 802.1AS > Basic > 802.1AS Configuration
screen, as shown in
Figure 92. Enable 802.1AS
3. After enabling 802.1AS (EAV), the Stacking page becomes unavailable.
S3300 Smart Managed Pro Switch
Mode. See
Figure 92, Enable 802.1AS. See
Configuring Switching
204
Advanced Stack Configuration
802.1AS Configuration
Figure 91,
on
on page 202.