Ospf Area Aggregation Settings - D-Link xStack Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Hello Interval (1-65535)
Dead Interval (1-65535)
Authentication
Password
Click the Apply button to accept the changes made.
Click the <<Back button to return to the previous window.

OSPF Area Aggregation Settings

This window is used to configure the OSPF area aggregation settings.
To view the following window, click L3 Features > OSPF > OSPFv2 > OSPF Area Aggregation Settings, as
shown below:
The fields that can be configured are described below:
Parameter
Area ID
IP Address
Figure 6-48 OSPF Virtual Link Settings - Edit window
Description
Enter the specification of the interval between the transmissions of OSPF Hello
packets, in seconds. The Hello Interval, Dead Interval, Authorization Type, and
Authorization Key should be the same for all routers on the same network.
Enter the specification of the length of time between the receipts of Hello packets
from a neighbor router before the selected area declares that router down. The Dead
Interval must be evenly divisible by the Hello Interval.
Select the authentication used. Options to choose from are None, Simple and MD5.
When choosing Simple authentication, a password must be entered. When choosing
MD5 authentication, a Key ID must be entered.
When Simple is selected in the Authentication drop-down menu, enter a simple text
password.
Figure 6-49 OSPF Area Aggregation Settings window
Description
Enter a 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely
identifies the OSPF area in the OSPF domain.
Enter the IP address that uniquely identifies the network that corresponds to the OSPF
Area.
229