Table of Contents
Advertisement
®
xStack
To view the following window, click Security > Access Authentication Control > Login Method Lists Settings, as
shown below:
The fields that can be configured are described below:
Parameter
Method List Name
Priority 1, 2, 3, 4
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove a Login Method List defined by the user.
Enable Method Lists Settings
Users can set up Method Lists to promote users with user level privileges to Administrator (Admin) level privileges
using authentication methods on the Switch. Once a user acquires normal user level privileges on the Switch, he or
she must be authenticated by a method on the Switch to gain administrator privileges on the Switch, which is defined
by the Administrator. A maximum of eight Enable Method Lists can be implemented on the Switch, one of which is a
default Enable Method List. This default Enable Method List cannot be deleted but can be configured.
The sequence of methods implemented in this command will affect the authentication result. For example, if a user
enters a sequence of methods like TACACS - XTACACS - Local Enable, the Switch will send an authentication
request to the first TACACS host in the server group. If no verification is found, the Switch will send an authentication
request to the second TACACS host in the server group and so on, until the list is exhausted. At that point, the Switch
will restart the same sequence with the following protocol listed, XTACACS. If no authentication takes place using the
XTACACS list, the Local Enable password set in the Switch is used to authenticate the user.
Successful authentication using any of these methods will give the user an "Admin" privilege.
DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
Figure 9-78 Login Method Lists Settings window
Description
Enter a method list name defined by the user of up to 15 characters.
The user may add one, or a combination of up to four of the following authentication
methods to this method list:
tacacs - Adding this parameter will require the user to be authenticated using the
TACACS protocol from a remote TACACS server.
xtacacs - Adding this parameter will require the user to be authenticated using the
XTACACS protocol from a remote XTACACS server.
tacacs+ - Adding this parameter will require the user to be authenticated using the
TACACS+ protocol from a remote TACACS+ server.
radius - Adding this parameter will require the user to be authenticated using the RADIUS
protocol from a remote RADIUS server.
local - Adding this parameter will require the user to be authenticated using the local user
account database on the Switch.
none - Adding this parameter will require no authentication needed to access the Switch.
346
Advertisement
Table of Contents
