Table of Contents
Advertisement
®
xStack
DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
Click the Apply button to accept the changes made.
Serial Port Settings
Here the user can adjust the Baud Rate and the Auto Logout values.
To view the following window, click System Configuration > Serial Port Settings, as shown below:
The fields that can be configured or displayed are described below:
Parameter
Baud Rate
Auto Logout
Data Bits
Parity Bits
Stop Bits
Click the Apply button to accept the changes made.
Warning Temperature Settings
On this page the user can configure the system warning temperature parameters.
To view the following window, click System Configuration > Warning Temperature Settings, as shown below:
The fields that can be configured are described below:
Parameter
Traps State
Log State
Figure 2-15 Serial Port Settings window
Description
This field specifies the baud rate for the serial port on the Switch. There are four
possible baud rates to choose from, 9600, 19200, 38400 and 115200. For a
connection to the Switch using the console port, the baud rate must be set to 115200,
which is the default setting.
Select the logout time used for the console interface. This automatically logs the user
out after an idle period of time, as defined. Choose from the following options: 2, 5, 10,
15 minutes or Never. The default setting is 10 minutes.
Displays the data bits used for the serial port connection.
Displays the parity bits used for the serial port connection.
Displays the stop bits used for the serial port connection.
Figure 2-16 Warning Temperature Settings window
Description
Here the user can enable or disable the traps state option of the warning temperature
setting.
Here the user can enable or disable the log state option of the warning temperature
16
Advertisement
Table of Contents
