Snmp User Table Settings; Snmp Host Table Settings - D-Link xstack DES-3810 series Reference Manual

®
xStack
NOTE: The Engine ID length is 10-64 and accepted characters can range from 0 to F.

SNMP User Table Settings

This window displays all of the SNMP User's currently configured on the Switch.
To view the following window, click Management > SNMP Settings > SNMP User Table Settings, as shown below:
The fields that can be configured are described below:
Parameter
User Name
Group Name
SNMP Version
SNMP V3 Encryption
Auth-Protocol
Priv-Protocol
Click the Apply button to accept the changes made.
Click the Delete button to remove the specific entry.

SNMP Host Table Settings

Users can set up SNMP trap recipients for IPv4.
To view the following window, click Management > SNMP Settings > SNMP Host Table Settings, as shown below:
DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
Figure 3-42 SNMP User Table Settings window
Description
An alphanumeric string of up to 32 characters. This is used to identify the SNMP users.
This name is used to specify the SNMP group created can request SNMP messages.
V3 – Indicates that SNMP version 3 is in use.
Use the drop-down menu to enable encryption for SNMP V3. This is only operable in
SNMP V3 mode. The choices are None, Password, or Key.
MD5 – Specifies that the HMAC-MD5-96 authentication level will be used. This field is
only operable when V3 is selected in the SNMP Version field and the Encryption field has
been checked. This field will require the user to enter a password.
SHA – Specifies that the HMAC-SHA authentication protocol will be used. This field is
only operable when V3 is selected in the SNMP Version field and the Encryption field has
been checked. This field will require the user to enter a password.
None – Specifies that no authorization protocol is in use.
DES – Specifies that DES 56-bit encryption is in use, based on the CBC-DES (DES-56)
standard. This field is only operable when V3 is selected in the SNMP Version field and
the Encryption field has been checked. This field will require the user to enter a password.
50