Setup #1 Screen - Graco PGM Instructions - Parts Manual

Appendix A - User Interface Display

Setup #1 Screen

A
#1 to #6 Buttons
Press to navigate to the Setup Screen with that number.
For example, press #3 to navigate to Setup Screen #3.
Command Value Source
Command Values can be controlled by the user-inter-
face touch screen or by an external machine connected
to the system via the External Control Interface.
Run Mode Bead Adjust
When this option is enabled the Bead Scale function
appears on the Home Screen. See the Home Screen
on page 85 for more information.
Job End Mode
The In Cycle signal can be dropped when the dispense
trigger is removed when Display is selected.
If Remote is selected the Job Complete signal is
required to remove the In Cycle signal.
Job End Delay (sec)
When Job End mode is set to Display the In Cycle signal
is removed after the time in this field.
88 3A5185B