Graco PGM Instructions - Parts Manual page 80

Accessory Parts
Dynamic Regulator Installation
1
Disconnect red airline from air tree.
2
Remove pressure relief safety valve from air
tree.
3
Screw in the cross with adjustable air pressure
regulator into the pressure relief safety valve
hole.
4
Attach the dynamic regulator assembly to the
hose connection on the air tree.
F . 40
IG
The dynamic regulator kit is used to control the static
pressure of a Therm-O-Flow (UH****). The PGM has a
maximum inlet pressure of 1500 psi. During dispense
the dynamic regulator kit will activate the normal regula-
tor located on the front panel of the Therm-O-Flow.
When the system is idle, the secondary regulator will
control static pressure.
80
1
4
5
6
2
3
7
5
Attach the red air hose to the dynamic regulator
assembly.
6
Attach the pressure relief safety valve to open
port on the cross fitting.
7
Attach to PGM control panel.
3A5185B