System Setup; Overview - Graco PGM Instructions - Parts Manual

Precision gear metering

Hide thumbs Also See for PGM:

Table of Contents

Enlarged version

System Setup

The PGM system compensates for temperature, flow, or

pressure fluctuations. However, if there is a hardware

change on the supply system or the dispense material is

changed, the PGM system must be setup again.

After material is loaded into the supply system, set up

the PGM system using the Setup screens. F

shows the major system setup steps. The following sub-

sections provide instructions to complete each setup

step. Once these steps are complete the module is

ready for operation.

NOTE: See Appendix A - User Interface Display on

page 82 for detailed operating instructions for each

user interface screen.

. 10

System Setup

Configure Control Settings (page 19)

Configure Mode Settings (page 19)

Configure Delay Settings (page 20)

Adjust Pressure Sensors (page 20)

Configure Errors (page 21)

End System Setup

3A5185B

Table of Contents