Table of Contents
Advertisement
Installation
Installation
Before Installation
•
Have all system and component documentation
available during installation.
•
See component manuals for specific data on compo-
nent requirements. Data presented here applies to
the PGM assemblies only.
•
Be sure all accessories are adequately sized and
pressure-rated to meet system requirements.
•
Use the PGM control center only with the PGM
metering assembly.
12
Overview
The basic steps to install a PGM system are shown
below. See the separate component manuals for
detailed information on supply systems and dispense
valves.
To avoid damaging the PGM system, use at least two
people to lift, move, or disconnect the system. The
system is too heavy for one person to lift or move.
Installation Steps
1. Mount control center.
2. Connect and ground control center.
3. Mount gear meter assembly.
4. Ground gear meter assembly.
5. Check ground continuity.
6. Connect fluid line between gear meter and dispense
valve. For remote mount dispense valves, con-
nect fluid supply line and air supply to gear meter.
7. Plumb filter assembly near air drop site that will be
used for gear meter assembly.
8. Connect other fluid and air lines to additional system
components as instructed in their manuals.
9. Install cable assemblies.
NOTICE
3A5185B
Advertisement
Table of Contents
Troubleshooting
