Restart Screen - ZyXEL Communications LTE3302-M432 User Manual

Table 72 Maintenance > Backup/Restore (continued)
LABEL
Upload
Reset
Note: If you uploaded the default configuration file you may need to change the IP address
of your computer to be in the same subnet as that of the default LTE Device IP address
(192.168.1.1). See
IP address.

23.9 Restart Screen

System restart allows you to reboot the LTE Device without turning the power off.
Click Maintenance > Restart to open the following screen.
Figure 112 Maintenance > Restart
Click Restart to have the LTE Device reboot. This does not affect the LTE Device's configuration.
Chapter 23 Maintenance
DESCRIPTION
Click Upload to begin the upload process.
Note: Do not turn off the LTE Device while configuration file upload is in progress.
After you see a "configuration upload successful" screen, you must then wait one minute
before logging into the LTE Device again. The LTE Device automatically restarts in this time
causing a temporary network disconnect.
If you see an error screen, click Back to return to the Backup/Restore screen.
Pressing the Reset button in this section clears all user-entered configuration information and
returns the LTE Device to its factory defaults.
You can also press the RESET button on the rear panel to reset the factory defaults of your LTE
Device. Refer to the chapter about introducing the Web Configurator for more information on
the RESET button.
Appendix A on page 158
LTE3302-M432 & LTE3312-M432 User's Guide
for details on how to set up your computer's
152