Restart Screen; Language Screen - ZyXEL Communications NBG6716 User Manual

Table 72 Maintenance > Backup/Restore (continued)
LABEL
Upload
Reset
Note: If you uploaded the default configuration file you may need to change the IP
address of your computer to be in the same subnet as that of the default NBG6716
IP address (192.168.1.1). See
your computer's IP address.

23.8 Restart Screen

System restart allows you to reboot the NBG6716 without turning the power off.
Click Maintenance > Restart to open the following screen.
Figure 124 Maintenance > Restart
Click Restart to have the NBG6716 reboot. This does not affect the NBG6716's configuration.

23.9 Language Screen

Use this screen to change the language for the Web Configurator.
Select the language you prefer and click Apply. The Web Configurator language changes after a
while without restarting the NBG6716.
NBG6716 User's Guide
DESCRIPTION
Click Upload to begin the upload process.
Note: Do not turn off the NBG6716 while configuration file upload is in progress.
After you see a "configuration upload successful" screen, you must then wait one minute
before logging into the NBG6716 again. The NBG6716 automatically restarts in this time
causing a temporary network disconnect.
If you see an error screen, click Back to return to the Backup/Restore screen.
Pressing the Reset button in this section clears all user-entered configuration information
and returns the NBG6716 to its factory defaults.
You can also press the RESET button on the rear panel to reset the factory defaults of your
NBG6716. Refer to the chapter about introducing the Web Configurator for more
information on the RESET button.
Appendix B on page 209
Chapter 23 Maintenance
for details on how to set up
187