20.3 What You Need To Know
The sum of the bandwidth allotments that apply to the WAN interface (LAN to WAN, WLAN to WAN)
must be less than or equal to the upstream bandwidth that you configure in the Bandwidth
Management > General screen
The sum of the bandwidth allotments that apply to the LAN interface (WAN to LAN, WAN to WLAN) must
be less than or equal to the downstream bandwidth that you configure in the Bandwidth Management
> General screen
20.4 General Screen
Use this screen to have the LTE Device apply bandwidth management.
Click Configuration > Management > Bandwidth MGMT to open the bandwidth management General
screen.
Figure 90 Configuration > Management > Bandwidth MGMT > General
The following table describes the labels in this screen.
Table 61 Configuration > Management > Bandwidth MGMT > General
LABEL
Bandwidth
Management
Bandwidth of
Upstream
Bandwidth of
Downstream
Chapter 20 Bandwidth Management
(Section 20.5 on page
Section 20.5 on page
133.
DESCRIPTION
This field allows you to have LTE Device apply bandwidth management.
Enable bandwidth management to give traffic that matches a bandwidth rule priority over
traffic that does not match a bandwidth rule.
Enabling bandwidth management also allows you to control the maximum or minimum
amounts of bandwidth that can be used by traffic that matches a bandwidth rule.
Specify the total amount of bandwidth that you want to dedicate to uplink traffic. The
recommendation is to set this to match the actual upstream data rate.
This is traffic from LAN/WLAN to WAN.
Specify the total amount of bandwidth that you want to dedicate to downlink traffic. The
recommendation is to set this to match the actual downstream data rate.
This is traffic from WAN to LAN/WLAN.
LTE3302-M432 & LTE3312-M432 User's Guide
133).
132