ZyXEL Communications LTE3302-M432 User Manual page 91

Figure 59 Configuration > Network > DHCP Server > General
The following table describes the labels in this screen.
Table 36 Configuration > Network > DHCP Server > General
LABEL DESCRIPTION
DHCP 1 Server
DHCP Server Select Enable to activate DHCP for LAN.
DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) allows individual
clients (computers) to obtain TCP/IP configuration at startup from a server. Enable the
DHCP server unless your ISP instructs you to do otherwise. Select Disable to stop the LTE
Device acting as a DHCP server. When configured as a server, the LTE Device provides
TCP/IP configuration for the clients. If not, DHCP service is disabled and you must have
another DHCP server on your LAN, or else the computers must be manually configured.
When set as a server, fill in the following four fields.
IP Pool Starting Address This field specifies the first of the contiguous addresses in the IP address pool for LAN.
Pool Size This field specifies the size, or count of the IP address pool for LAN.
Chapter 9 DHCP Server
LTE3302-M432 & LTE3312-M432 User's Guide
91