ZyXEL Communications LTE3302-M432 User Manual page 63

Table 16 Configuration > Network > WAN > Management WAN Edit (continued)
LABEL
Dial-Up Profile
Country
Service Provider
APN
Dialed Number
Account
Password
Authentication
Primary DNS
Secondary DNS
Roaming
Connection Control
Maximum Idle Time
MTU
Network Monitoring
Loading Check
Chapter 6 WAN
DESCRIPTION
Select Auto-Detection to have the LTE Device use the inserted SIM card's default settings
to connect to any available mobile network.
Select Manual and enter the information provided by your service provider to connect to
the service provider's mobile network.
Select the country in which you use the LTE Device.
Select the name of your service provider. The options vary depending on the country you
selected.
If your service provider is not in the list, select Others.
Connections with different APNs (Access Point Names) may provide different services
(such as Internet access or MMS (Multi-Media Messaging Service)) and charge method.
The corresponding APN automatically displays when you select a pre-defined service
provider.
If you select Others in the Service Provider field, manually enter the APN provided by your
service provider. You can enter up to 32 ASCII printable characters. Spaces are allowed.
This is the phone number (dial string) used to dial up a connection to your service
provider's base station. Your service provider should provide the phone number. For
example, *99# is the dial string to establish a GPRS or 3G/4G connection in Taiwan.
The corresponding phone number automatically displays when you select a pre-defined
service provider.
If you select Others in the Service Provider field, manually enter the phone number
provided by your service provider.
Type the user name (of up to 64 ASCII printable characters) given to you by your service
provider.
Type the password (of up to 64 ASCII printable characters) associated with the user
name above.
The LTE Device supports PAP (Password Authentication Protocol) and CHAP (Challenge
Handshake Authentication Protocol). CHAP is more secure than PAP; however, PAP is
readily available on more platforms
Select an authentication protocol (PAP, or CHAP) used by the service provider.
Otherwise, select Auto to have the LTE Device accept either CHAP or PAP.
Enter the first DNS server address assigned by the service provider.
Enter the second DNS server address assigned by the service provider.
3G/4G roaming is to use your mobile device in an area which is not covered by your
service provider. Enable roaming to ensure that your LTE Device is kept connected to the
Internet when you are traveling outside the geographical coverage area of the network
to which you are registered.
Select Auto Reconnect (always-on) if you do not want the connection to time out.
Select Connect-on-Demand if you do not want the connection up all the time and
specify an idle time-out in the Maximum Idle Time field.
Specify the time in minutes that elapses before the LTE Device automatically disconnects
from the service provider.
Enter the MTU (Maximum Transmission Unit) of each data packet, in bytes, that can move
through the WAN connection.
Select this option to have the LTE Device test the WAN connection by periodically
sending DNS Query to a DNS server or sending a ping (ICMP Checking) to either the
default gateway or the addresses you specify in the Target1 and Target2 fields.
Select this option to check how many packets have been transmitted or received
through the WAN connection within a time period specified in the Check Interval field.
LTE3302-M432 & LTE3312-M432 User's Guide
63