Network Scan - ZyXEL Communications LTE3302-M432 User Manual

Table 16 Configuration > Network > WAN > Management WAN Edit (continued)
LABEL
Check Interval
Check Timeout
Latency Threshold
Fail Threshold
Target1/Target2
Bridge
IGMP
IGMP Proxy
IP Type

6.5 Network Scan

Use this screen to set how you want the LTE Device to connect to an available mobile network. Click
Network > WAN > Network Scan from the Configuration menu.
Chapter 6 WAN
DESCRIPTION
Type a number of seconds (0 to 99999) to set the time interval between checks. Allow
more time if your destination IP address handles lots of traffic.
Type the number of seconds (0 to 99999) for your LTE Device to wait for a response to the
ping or DNS query before considering the check to have failed. This setting must be less
than the Check Interval. Use a higher value in this field if your network is busy or
congested.
Type a number of milliseconds (0 to 99999) for the latency threshold.
If the specified latency threshold is exceeded, the LTE Device considers the check to
have failed and makes a new connection after (Latency Threshold * Fail Threshold)
seconds.
Type how many WAN connection checks can fail (0 to 99999) before the connection is
considered "down" (not connected). The LTE Device still checks a "down" connection to
detect if it reconnects.
Select DNS1 to have the LTE Device send a DNS query to the first DNS server address
assigned by the service provider.
Select DNS2 to have the LTE Device send a DNS query to the second DNS server address
assigned by the service provider.
Select Gateway to have the LTE Device ping the WAN interface's default gateway IP
address.
Select Other Host and enter a domain name or IP address of a reliable nearby computer
to have the LTE Device ping that address.
Select this check box to change the LTE Device's operating mode to Bridge mode. The
computer connected to the first Ethernet LAN port is allowed to get an individual IP
address from the ISP's DHCP server directly.
Select IGMP v1, IGMP v2, IGMP v3 or Auto to enable multicasting. This applies to traffic
routed from the WAN to the LAN.
Select Disable to turn off this feature. This may cause incoming traffic to be dropped or
sent to all connected network devices.
This field is available only when IGMP is enabled.
Select this option to have the LTE Device act as an IGMP proxy on this connection. This
allows the LTE Device to get subscribing information and maintain a joined member list
for each multicast group. It can reduce multicast traffic significantly.
Select IPv4 if you want the LTE Device to run IPv4 only.
Select IPv4/IPv6 to allow the LTE Device to run IPv4 and IPv6 at the same time.
Select IPv6 if you want the LTE Device to run IPv6 only.
LTE3302-M432 & LTE3312-M432 User's Guide
64