Table 59 Configuration > Management > Remote MGMT > WWW (continued)
LABEL
Access Status
Secured Client IP
Address
Cancel
Apply
19.5 The Remote Management Screen
Use this screen to configure through which IP address can access the LTE Device. You can also specify
the port numbers the IP addresses must use to connect to the LTE Device. Click Configuration >
Management > Remote MGMT > Remote Management to open the following screen.
Note: The firewall will be disabled when remote management is enabled. To activate the
firewall, you'll need to create a new firewall rule to allow the remote management
traffic to come in from the WAN side.
Figure 88 Configuration > Management > Remote MGMT > Remote Management
The following table describes the fields in this screen.
Table 60 Configuration > Management > Remote MGMT > Remote Management
LABEL
Remote
Management
IP Address
Netmask
Chapter 19 Remote Management
DESCRIPTION
Select the interface(s) through which a computer may access the LTE Device using this HTTP
service.
If you activated UPnP, select WAN to allow the UPnP traffic to come in from the WAN side
successfully.
Select All to allow all computers to access the LTE Device using this HTTP service.
Otherwise, check Selected and specify the IP address of the computer that can access the
LTE Device.
Click Cancel to exit this screen without saving.
Click Apply to save your customized settings and exit this screen.
DESCRIPTION
Select the Enable check box to allow access to the LTE Device from the IP address and activate
the settings you've made in the WWW screen.
This is the IP address of a computer that may use to access the LTE Device.
This is the subnet mask identifying a computer that may access remotely to the LTE Device.
LTE3302-M432 & LTE3312-M432 User's Guide
129