Add/Edit Static Route - ZyXEL Communications LTE3302-M432 User Manual

Figure 72 Configuration > Network > Routing > Static Route
The following table describes the labels in this screen.
Table 45 Configuration > Network > Routing > Static Route
LABEL
Add Static Route
#
Status
Destination
Subnet Mask
Gateway
Modify

12.2.1 Add/Edit Static Route

Click the Add Static Route button or a rule's Edit icon in the Static Route screen. Use this screen to
configure the required information for a static route.
Figure 73 Configuration > Network > Routing > Static Route: Add/Edit
Chapter 12 Routing
DESCRIPTION
Click this to create a new rule.
This is the number of an individual static route.
This field indicates whether the rule is active (yellow bulb) or not (gray bulb).
This parameter specifies the IP network address of the final destination. Routing is always
based on network number.
This parameter specifies the IP network subnet mask of the final destination.
This is the IP address of the gateway. The gateway is a router or switch on the same network
segment as the device's LAN or WAN port. The gateway helps forward packets to their
destinations.
Click the Edit icon to open a screen where you can modify an existing rule.
Click the Delete icon to remove a rule from the LTE Device.
LTE3302-M432 & LTE3312-M432 User's Guide
107