Snmpv3 Encryption - Ricoh SP 4510DN User Manual

5. Enhanced Network Security

SNMPv3 Encryption

When using SmartDeviceMonitor for Admin/Device Manager NX Lite or another application that
communicates via SNMPv3, you can encrypt the data transmitted.
By making this setting, you can protect data from being tampered with.
1. Log in as the network administrator from Web Image Monitor.
2. Point to [Device Management], and then click [Configuration].
3. Click [Network Security] under "Security".
4. Click [Encryption Only] in the "Permit SNMPv3 Communication" area of the "SNMP"
section, and then click [OK].
5. Log out.
1. Log in as the network administrator from the control panel.
2. Display the "Permit SSL/TLS Communication" screen.
[System Settings]
3. Specify SNMPv3 encryption.
[Encryption Only]
4. Log out.
• To use SmartDeviceMonitor for Admin/Device Manager NX Lite for encrypting the data for
specifying settings, you need to specify the network administrator's Encryption Password setting
and Encryption Password in SNMP Authentication Information in SmartDeviceMonitor for Admin/
Device Manager NX Lite, in addition to specifying Permit SNMPv3 Communication on the printer.
For details about specifying Encryption Password in SmartDeviceMonitor for Admin/Device
Manager NX Lite, see SmartDeviceMonitor for Admin Help.
• If network administrator's [Encryption Password] setting is not specified, the data for transmission
may not be encrypted or sent. For details about specifying the network administrator's [Encryption
Password] setting, see page 19 "Registering and Changing Administrators".
• This can also be specified via Web Image Monitor. For details, see the procedure for SP 4510DN.
152
[Interface Settings] [Network]
[OK]
[Permit SNMPv3 Communication]