Ricoh SP 4510DN User Manual page 77

Message
"Connect failed:WirelessCard Turn
power off, check card."
"Cover Open. Please close the
indicated cover."
"Duplex mode is in off position for
(tray name)"
"Ethernet Board Error"
"Exceeded max. No. of files."
"Exceeded max. No. of pages."
"Exceeded max. print size. Press
[FormFeed] or [JobReset]."
"Exceeded max. print size. Press
[JobReset]."
"Failed to connect to server for
Remote Diagnostics."
Cause
The printer cannot detect the
wireless LAN interface
board.
A cover of the printer is open. Close the cover as indicated
The duplex mode for the
indicated tray is not
available.
An error on the Ethernet is
detected.
While printing a Sample
Print, Locked Print, Hold Print,
or Stored Print file, the
maximum file capacity was
exceeded.
While printing a Sample
Print, Locked Print, Hold Print,
or Stored Print file, the
maximum page capacity was
exceeded.
The specified paper size
exceeds the maximum size
supported by this printer.
The specified paper size
exceeds the maximum size
supported by this printer.
The printer cannot
communicate with Remote
Communication Gate.
When Messages Are Displayed
Solution
Check that the board is
supported or installed
correctly.
on the control panel.
You can use one-sided
printing only. Press [Change]
to change the tray's settings,
press [JobReset] to reset the
job, or press [Form Feed] to
force printing.
Turn the printer off, and then
turn it on again. If the
problem persists, contact
your sales or service
representative.
Delete unneeded files stored
in the printer.
• Delete unneeded files
stored in the printer.
• Reduce the number of
pages to print.
Press [Form Feed] to force
printing or [JobReset] to
cancel printing.
Press [JobReset] to cancel
printing.
Check the connection to the
Remote Server Gate.
75