Configuring Psf/400 With Crtpsfcfg - Ricoh SP 4510DN User Manual

Hide thumbs Also See for SP 4510DN:

Table of Contents

3. Configuring System i for an IPDS Printer

• Device Type (TYPE)

Specify *IPDS.

• Device Model (MODEL)

• LAN attachment (LANATTACH)

Specify *IP.

• Port Number (PORT)

Specify 5001, which is the printer's default port number. Use Web Image Monitor to set or

view the IPDS port number.

• Font (FONT)

Enter an appropriate value.

• Form Feed (FORMFEED)

Specify *AUTOCUT.

• Activation timer (ACTTMR)

This value specifies the number of seconds that PSF/400 waits for a printer to respond to an

activation request. If only one system will be using the printer, use the default value (170

seconds). If more than one system will be using the printer, specify *NOMAX, which will

cause PSF/400 to wait indefinitely for a response to an activation request.

• Remote Location (RMTLOCNAME)

Enter the IP address or hostname of the printer.

• User-Defined Object (USRDFNOBJ)

To use a PSF configuration object, specify its name and library here. The object type must be

*PSFCFG. A single PSF configuration object may be referenced by multiple device

descriptions, if required.

Configuring PSF/400 with CRTPSFCFG

The PSF configuration object created with this command is used by PSF/400 when printing IPDS files

only if the object is specified with the USRDFNOBJ parameter in the printer device description.

To configure System i for IPDS printing:

At the System i command line, enter a command in the form:

CRTPSFCFG PSFCFG(AFP/NETWRKPRT) IPDSPASTHR(*YES) RLSTMR(*SEC15)

TEXT('printer name')

Table of Contents