Configuring The Communication Using Simatic S7 Control; Installing The Gsd - Siemens sinamics G120 Operating Instructions Manual
Low voltage inverters chassis devices with cu250s-2 control units and encoder evaluation
Hide thumbs
Also See for sinamics G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Advertisement
4.8.3.3
Configuring the communication using SIMATIC S7 control
● If the inverter is listed in the hardware library of HW-Conifg, you can configure the
communication in the SIMATIC control.
● If the inverter is not listed in the hardware library, you can either install the newest
STARTER or Startdrive version or install the GSD of the inverter via "Extras/GSD-Install
file" in HW-Config.
4.8.3.4
Installing the GSD
Procedure
To load the GSD of the inverter in the control, proceed as follows:
1. Obtain the GSD
– either on the Internet:
– or from your inverter. To do this, insert a memory card into the inverter and set p0804
2. Unzip the GSDfile in a folder on your computer.
3. Import the GSDinto the configuration tool of your control.
You have now installed the GSD file.
Converter with CU250S-2 Control Unit
Operating Instructions, 01/2016, FW V4.7 SP6, A5E31759476B AE
GSD (http://support.automation.siemens.com/WW/view/en/22339653/133100)
= 12. In this way, you will save the GSD on the memory card as (DPGSD.ZIP)
compressed file in the directory /SIEMENS/SINAMICS/DATA/CFG .
4.8 Connecting the inverter to the fieldbus
Installing
113
Advertisement
Table of Contents
