Writing The License Key To The Card - Siemens sinamics G120 Operating Instructions Manual
Low voltage inverters chassis devices with cu250s-2 control units and encoder evaluation
Hide thumbs
Also See for sinamics G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Advertisement
Appendix
A.2 Activating licensed functions
A.2.3
Writing the license key to the card
You write the license key to the memory card by writing the individual positions – in an
ascending order – into the bits of parameter p9920, and then subsequently activate the key
using p9921.
The procedure for STARTER and BOP-2, based on the fictitious "E1MQ-4BEA" license key,
is described below.
Note
If you subsequently purchase an additional license, then you will require a new license key.
You must overwrite the old license key. The new license key can have more than 9
positions.
You set p9920 to 0, by setting p9920[0] = 0.
Writing the license key to the memory card and activating
Procedure
In order to write and activate the license key using STARTER, proceed as follows:
1. Go online and open the expert list via "Project/Control_Unit/Expert list".
2. In the expert list, go to parameter p9920
3. Enter the license key (example: "E1MQ-4BEA") - always use uppercase letters:
– p9920[0] = E
– p9920[1] = 1
– ...
– p9920[7] = E
– p9920[8] = A
4. Set p9921 = 1.
After activation, P9921 jumps back to 0.
You have activated the license key using STARTER.
482
Operating Instructions, 01/2016, FW V4.7 SP6, A5E31759476B AE
Converter with CU250S-2 Control Unit
Advertisement
Table of Contents
