Post Height Pre-Adjustment - Panasonic AJ-D400P Service Manual

1-4. Post Height Pre-adjustment

MODE EJECT (POWER OFF)
TOOL VFK1153, VFK1154 (Flange Tool)
1. Turn the power OFF and then set the tube* to
cover the sensor LED and place the unit in no
tape loading mode.
NOTE: Make a tube* by yourself.
2. Install the Mech. Neutral Plate (VFK1153) and
adjust each post height as shown in figure.
3. Adjust the each post to Lower limit by
VFK1154 as shown in figure.
4. VFK1149 use for Post height adjustment of S4
and S5 post. VFK1151 use for Post height
adjustment of T3 and T4 post.
Post Limit
S5 Post Lower*
S4 Post Lower*
T3 Post Lower
T4 Post Lower
Note:
Lower* : Turn S4 and S5 posts 1 round more
counterclockwise from lower limit
position.
Post Driver
VFK1149
VFK1149
VFK1151 (2.5mm Nut Driver)
VFK1151 (2.5mm Nut Driver)
Lower Limit
Upper Limit
VFK1154
VFK1153
VFK1154
VFK1153